Shaft layout

The values shown correspond to a generic installation. During the planning phase, all applicable regulations stipulated by relevant notified bodies and all applicable national regulations should be considered. Please consult with TK Elevator for guaranteed dimensions for your project. Additional rated loads and dimensions are available upon request.
Values
SD / SWsee dimensions page
SH3400 mm
SPmin. 900 – 1200 mm
THmax. 30 m / min. 2900 mm
HSTmin. DH + 520 mm
HST2min. 500 mm
CH2100 / 2200 mm
DH2000 / 2100 mm
DW600 – 900 mm
EntranceSingle entrance
Double entrance 180° or 90°
DoorsL2, side-opening with 2 panels
C4, central-opening with 4 panels
Key
SDshaft depth
SWshaft width
SHshaft head
SPshaft pit
THtravel height
HSTmin. height between floors
CHcabin height
CWcabin width
CDcabin depth
DHdoor height
DWdoor width
FFLfinished floor level
UFLunfinished floor level

Note: Shaft dimensions with standard tolerance of ±25 mm on each side.

Door types and entrance configurations

Door types and entrance configurations

EOX Renew is available with side-opening doors with 2 panels and central-opening doors with 4 panels. Regarding the installation of the shaft doors, all choices are available: in a recess, completely or partially positioned in the shaft. Illustrations on this page show shaft doors installed fully in the shaft and do not reflect real-life proportions, sizes or distances. Consult dimensions chart page or your TK Elevator sales representative for project calculations and further information.
Key 
L2Side-opening door with 2 panels
C4Central-opening door with 4 panels
SSingle entrance
D180Double entrance at 180°
D90Double entrance at 90°

L2 / S

Side-opening door with 2 panels, single entrance

L2 / D180

Side-opening door with 2 panels, double entrance at 180°

L2 / D90

Side-opening door with 2 panels, double entrance at 90°

C4 / S

Central-opening door with 4 panels, single entrance